Uni-Form Coping System | Bolt Through Design | Interchangeable Riding Surface
Uni-Form Coping System | Bolt Through Design | Interchangeable Riding Surface
Uni-Form Coping System | Bolt Through Design | Interchangeable Riding Surface
Uni-Form Coping System | Bolt Through Design | Interchangeable Riding Surface
Uni-Form Coping System | Bolt Through Design | Interchangeable Riding Surface
xSeriesLogo

X Series

The X-Series features an interchangeable riding surface. Our exclusive bolt through design and stainless steel fasteners allows the surface to be replaced or changed with minimal effort. If you are looking for a Skatelite Pro™, stainless steel, or Ramp Armor® riding surface with a steel framework and low maintenance, the X-Series is your ramp.

  • Uni-Form Coping System
  • Bolt through Design
  • Interchangeable Riding Surface

THICK 3/16″ LASER CUT FRAMEWORK

By using laser table technology to cut our thick framework, we are able to hold incredibly tight tolerances which enables us to maintain perfect ramp geometry. This also ensures that each ramp section fits together perfectly for a seamless feel and appearance. (ASTM A1011/A653)

American Ramp Company THICK 3/16" LASER CUT FRAMEWORK

BOLT THROUGH DESIGN

1st Layer:
Solid sheet of 12-gauge galvanized steel provides outstanding support and is key in our advanced bolt-through design. (ASTM A1011/A653)

Interchangable Layer:
MaxGrip™: 12-gauge galvanized steel coated with our exclusive MaxGrip™ finish. (Stainless steel optional.) (ASTM A1011/A653)
Note: We use galvanized steel rather than standard black steel and zinc primer used by the competition. This is important because the galvanized coating will not scratch off and rust over time like zinc primer.
Phenolics (Ramp Armor®, Skatelite Pro™, Ramp X): Paper based phenolic resin surfaces available in black or tan. (ASTM D638/D790)
Note: Ramp Armor® has twice the resin content of Skatelite Pro™ which makes it absorb less water, increases strength, and lasts longer in a municipal skatepark.

American Ramp Company Ramp Armor

TAMPER-RESISTANT HARDWARE

All hardware used is stainless steel and the pin-hex head bolts ensure that they are only removed when you decide. (ASTM F593)

American Ramp Company TAMPER-RESISTANT HARDWARE

GALVANIZED UNI-FORM COPING SYSTEM

We begin with a piece of steel plate and form it to have the same profile as 2-3/8″ pipe. The ¼” coping reveal is guaranteed since it is not dependant on the framework, which will expand/contract with the weather conditions, and the riding surface is protected by steel behind and below the coping radius. (ASTM F2334-09-5.4)

American Ramp Company GALVANIZED UNI-FORM COPING SYSTEM

13-GAUGE GALVANIZED SOLID STEEL ENCLOSURES

These optional enclosure panels make the ramps look more finished, limit access to the underside of the ramps, and eliminate the accumulation of trash and debris under the ramps. (ASTM A1011/A653)

SteelEnclosures_zoom-300x214

HOT-DIP GALVANIZED GRINDRAILS

The galvanized coating ensures that even after years of grinding these areas will still look great and be free of rust. (ASTM A123)

GalvanizedRail_zoom

CNC PRECISION

All Ramp Armor® is pre-cut, pre-drilled and pre-countersunk on our CNC router to perfectly match the hole pattern of 1st layer of laser cut steel.  (ASTM D638/D256)

CNCprecision_zoom-300x214

Customers

CRC_PartnersBanner